Welcome,
Guest
Login
or
Register
Need Bees Removed?
Home
Help
Search
Login
Register
Beemaster's International Beekeeping Forum
»
BEEKEEPING LEARNING CENTER
»
GENERAL BEEKEEPING - MAIN POSTING FORUM.
»
honey extractor shaft removal?
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: honey extractor shaft removal? (Read 1637 times)
the-ecohouse.com
House Bee
Posts: 263
honey extractor shaft removal?
«
on:
June 29, 2012, 08:45:57 am »
Hi Guys i'm trying to remove this shaft from my extractor motor any ideas on how to do that?
Logged
Joe D
Super Bee
Posts: 2246
Gender:
Re: honey extractor shaft removal?
«
Reply #1 on:
June 29, 2012, 09:39:53 am »
Eco is there a set screw in the side of the coupling, in the small whole in the second picture, and some times there is 2 set screws one on top of the other. If you have taken it out you may have to knock or press the coupling off. Good luck.
Joe
Logged
the-ecohouse.com
House Bee
Posts: 263
Re: honey extractor shaft removal?
«
Reply #2 on:
June 29, 2012, 09:48:20 am »
nice i'll give that a go, thought it might be a split pin cheers
Logged
Beeboy01
Field Bee
Posts: 739
Gender:
Oh Look A Honey Bee !!!
Re: honey extractor shaft removal?
«
Reply #3 on:
June 29, 2012, 06:27:08 pm »
If it was a split pin the hole would go all the way through the shaft so it could be pushed out by a punch. Once you get it apart you might need to file down the spot where the setscrew dug into the shaft, It will make the reassembly a whole lot easier.
Logged
Print
Pages: [
1
]
Go Up
« previous
next »
Beemaster's International Beekeeping Forum
»
BEEKEEPING LEARNING CENTER
»
GENERAL BEEKEEPING - MAIN POSTING FORUM.
»
honey extractor shaft removal?
anything