Beemaster's International Beekeeping Forum
BEEKEEPING LEARNING CENTER => GENERAL BEEKEEPING - MAIN POSTING FORUM. => Topic started by: the-ecohouse.com on June 29, 2012, 08:45:57 am
-
Hi Guys i'm trying to remove this shaft from my extractor motor any ideas on how to do that?
(http://s16.postimage.org/qtffjxsxd/2012_06_29_21_31_12.jpg) (http://postimage.org/image/qtffjxsxd/)
(http://s16.postimage.org/5xt58owq9/2012_06_29_21_31_23.jpg) (http://postimage.org/image/5xt58owq9/)
-
Eco is there a set screw in the side of the coupling, in the small whole in the second picture, and some times there is 2 set screws one on top of the other. If you have taken it out you may have to knock or press the coupling off. Good luck.
Joe
-
nice i'll give that a go, thought it might be a split pin cheers
-
If it was a split pin the hole would go all the way through the shaft so it could be pushed out by a punch. Once you get it apart you might need to file down the spot where the setscrew dug into the shaft, It will make the reassembly a whole lot easier.