This turned out so efficient. I have a 12volt model with 25ft of lamp cord and battery clamps. I got 6 digital timers w/ memory for 1.00ea at the dollar store. One blue one preset for 2 min. and 5 red preset for 10 min. I pull up, pop the hood, set the blue timer on the battery and a red timer on each of the first 6 hives. Out of the back I pull out my med size cooler/ mite treatment kit. First I pull out the burner, place it on the ground in front of the first colony along with the tub of acid w/ measuring spoon and a damp rag. I run the cord to the truck battery and clamp one side on. Back to the cooler i grab a roll of duct tape and 6 strips of carpet pad 2" X 18". Place 1 pad in front of each of the first 6
1st colony
Fill the burner and slide it in. Push carpet pad in to plug bottom enterence. Duct tape top enterance. Back to truck Hook up battery and start blue timer. At 2 minutes the timer beeps. disconnect battery and start red 10min timer on top of 1st colony. Slide out burn, replug with carpet pad and cool with a damp rag. Move to 2nd colony and start the whole proccess again. When I get to the 6th colony the 1st is beeping that the 10 min seal up time is up.
I can do 1/2 doz in less the 20 minutes