Welcome, Guest

Author Topic: BRUSHES SPECIAL  (Read 2081 times)

Offline Spomenko

  • New Bee
  • *
  • Posts: 26
BRUSHES SPECIAL
« on: July 01, 2010, 02:56:56 am »
You do not have to drag machine for remove bee with them, or remove the blowers while,for upset frame. This is two  brushes to 2 cm apart so that the angle of attacking bees and chasing away the frame is not too sharp (80 90 degrees)
PROCEDURE: Remove ram, and shook the bees pass through the brushes in the picture and then remove frame purr, because the frame with all 6 pages pass brushes in one move and not stay even one bee and if it happens, and pass it again no way to guarantee that remain on the frame or a bee, and all remain get rid above an the hive and not blow ap or packed in the pupil of machine for remove bee.Bees are not cope and all the frames you have is an place,not was upset as with other devices.

Offline Spomenko

  • New Bee
  • *
  • Posts: 26
Re: BRUSHES SPECIAL
« Reply #1 on: July 01, 2010, 03:47:04 am »
so sory,


Uploaded with ImageShack.us

Offline techmant

  • Brood
  • Posts: 1
Re: BRUSHES SPECIAL
« Reply #2 on: July 16, 2010, 03:16:39 pm »
Hey that looks like a good idea  !!

Offline BoBn

  • House Bee
  • **
  • Posts: 195
  • Gender: Male
    • h
Re: BRUSHES SPECIAL
« Reply #3 on: July 17, 2010, 01:21:52 am »
Great idea.  Brush both sides of the frames at once. 
It looks like the double brush hangs on a super.

If you had good technique, it probably is less disruptive than using a blower.

"Millions of innocent men, women, and children, since the introduction of Christianity, have been burnt, tortured, fined, and imprisoned; yet we have not advanced one inch toward uniformity. What has been the effect of coercion? To make one-half the world fools and the other half hypocrites."
--Thomas Jefferson

 

anything