Welcome, Guest

Author Topic: Heavy rich pine boards  (Read 3896 times)

Offline don2

  • Doak
  • Field Bee
  • ***
  • Posts: 536
  • Gender: Male
Heavy rich pine boards
« on: May 16, 2013, 10:25:23 pm »
What do you all think about using this wood for top and/or bottom boards? think the scent will be too strong for the bees?  :) d2

Offline asprince

  • Super Bee
  • *****
  • Posts: 1743
  • Gender: Male
Re: Heavy rich pine boards
« Reply #1 on: May 17, 2013, 01:37:39 pm »
Heart pine? No problem for the bees but if it is pretty wood it would be a waste of quality wood.


Steve
Politics is supposed to be the second oldest profession. I have come to realize that it bears a very close resembalance to the first. - Ronald Reagan

Offline don2

  • Doak
  • Field Bee
  • ***
  • Posts: 536
  • Gender: Male
Re: Heavy rich pine boards
« Reply #2 on: May 17, 2013, 01:42:06 pm »
One of the 10 ft boards was red almost all the way. I have already cut it the desired length for bottom boards. :'(  ;) :) d2

Offline Joe D

  • Super Bee
  • *****
  • Posts: 2246
  • Gender: Male
Re: Heavy rich pine boards
« Reply #3 on: May 17, 2013, 09:03:18 pm »
I have been making supers out of some 1x8x12's of old heart pine.  I usually make BB and tops out of plywood.




Joe

Offline rwurster

  • House Bee
  • **
  • Posts: 89
Re: Heavy rich pine boards
« Reply #4 on: May 18, 2013, 05:30:39 am »
I pick up furniture people have on the curb and turned it all into tops/bottoms.  Some of the dressers are scented with horrid smelling perfumes.  Never had any problems...  It is nice to have one piece tops instead of gluing boards together.  Painting also tends to seal in the stink, ripe pine has never posed a problem for me either.
Zone 5a @ 4700 ft. High Desert
Facebook Link

Offline capt44

  • Field Bee
  • ***
  • Posts: 740
  • Gender: Male
  • If it don't work I'll always think it should have
    • RV BEES
Re: Heavy rich pine boards
« Reply #5 on: June 06, 2013, 11:20:45 pm »
I use pine 2x4's for making screened bottom boards.
I also use rough cut 1x12's and plane it down to 3/4 inch thick.
I get my best lumber from the saw mills.
Richard Vardaman (capt44)