Welcome, Guest

Author Topic: KTBH Feeder  (Read 4969 times)

BaB

  • Guest
KTBH Feeder
« on: December 16, 2010, 02:16:55 pm »
I had started a post under "Comb", but after reading many post on what I wanted to do I changed my mind and tried to copy a couple other post on making a Kenyan Top Bar Hive Feeder. I used 1 inch cedar 3 3/4 inches wide and 17 1/4 long to fit my hive then I used the same material only 3 1/2 wide for the sides and bottom, I cut them at 22 1/2 miter to fit my hive, glued with Titty bond 3 and screwed all the boards together, Then I took Plexiglas and cut it to match my frame and one side I cut a slot 5 inches wide and 1/2 inch deep at the center top, after a couple tries I used the correct material, liquid nails, clear and glued the Plexi to the frame. I finished it off by melting some paraffin wax and pouring it inside turning the feeder in different directions so all the edges got covered and sealed. I took some of my bottom screen #8 wire and cut it so it would go to the bottom of the feeder and hang out the slot I cut this way the girls have a ladder to climb on. The picture on on my Photobucket -> http://s1090.photobucket.com/albums/i373/MRTMEA
It will hold 1 gallon of sugar water
« Last Edit: December 16, 2010, 02:32:37 pm by Robo »

Offline Tommyt

  • Field Bee
  • ***
  • Posts: 855
  • Gender: Male
Re: KTBH Feeder
« Reply #1 on: December 16, 2010, 02:50:48 pm »
Nice job hope it serves you well
I started feeding mine  days ago
I was out watching them today
they are happy happy the hive is
alive like it was April
I don't know what they are getting
but they are coming in with white
Pollen bags Full, hope the feed
has gotten them building comb
this is a small KTBH with only a
pound or so Bees ,The way it looks
These girls maybe a full hive by spring.
I need to give them some Patties

Tommyt
"Not everything found on the internet is accurate"
Abraham Lincoln

Offline ineclipse

  • New Bee
  • *
  • Posts: 16
Re: KTBH Feeder
« Reply #2 on: January 02, 2011, 01:26:38 am »
Very cool.
My only question would be... how do you clean it out between feeding times?

Offline AllenF

  • Galactic Bee
  • ******
  • Posts: 8192
  • Gender: Male
Re: KTBH Feeder
« Reply #3 on: January 02, 2011, 06:21:42 pm »
What type of wood did you use for that hive?   Kinda looks like cedar.  Looks good.

Offline theDude

  • Brood
  • Posts: 2
Re: KTBH Feeder
« Reply #4 on: January 24, 2011, 10:29:03 am »
To quote BaB:

"I used 1 inch cedar 3 3/4 inches wide and 17 1/4 long to fit my hive then I used the same material only 3 1/2 wide for the sides and bottom, I cut them at 22 1/2 miter to fit my hive, glued with Titty bond 3 and screwed all the boards together"

Offline Gord

  • New Bee
  • *
  • Posts: 11
Re: KTBH Feeder
« Reply #5 on: February 25, 2011, 10:11:03 pm »
Really nice setup !